Today was a productive day, I was able to get a good deal of stuff done. i finished the front floors, por15'd the dividers and the floor, removed the old master cylinder and also replaced the rear axle seal. I cleaned out the gas tank and mounted it, ran some new fuel line, put seals around the front doors and the treasure chest doors. Ground out the trans so it would accept a 12v flywheel (this was awful!)

I think that thats it, Wednesday some parts will come in i should be able to get the majority of them installed and working by the end of the week. The engine should be finished this week also. The engine should be great, a 1776 single port with dual weber carbs.

At this rate the truck should be on the road in about a month i would guess...